By Date

The in vitro micronucleus test is a genotoxicity test for the detection of micronuclei in the cytoplasm of interphase cells. Micronuclei may originate from acentric chromosome fragments (i.e. lacking a centromere), or whole chromosomes that are unable to migrate to the poles during the anaphase stage of cell division. The assay detects the activity of clastogenic and aneugenic test substances in cells that have undergone cell division during or after exposure to the test substance. This Test Guideline allows the use of protocols with and without the actin polymerisation inhibitor cytochalasin B. Cytochalasin B allows for the identification and selective analysis of micronucleus frequency in cells that have completed one mitosis, because such cells are binucleate. This Test Guideline also allows the use of protocols without cytokinesis block provided there is evidence that the cell population analysed has undergone mitosis.   

This method provides information on health hazard likely to arise from exposure to test substance (liquids, solids and aerosols) by application on the eye. This Test Guideline is intended preferably for use with albino rabbit. The test substance is applied in a single dose in the conjunctival sac of one eye of each animal. The other eye, which remains untreated, serves as a control. The initial test uses an animal; the dose level depends on the test substance nature. A confirmatory test should be made if a corrosive effect is not observed in the initial test, the irritant or negative response should be confirmed using up to two additional animals. It is recommended that it be conducted in a sequential manner in one animal at a time, rather than exposing the two additional animals simultaneously. The duration of the observation period should be sufficient to evaluate fully the magnitude and reversibility of the effects observed. The eyes should be examined at 1, 24, 48, and 72 hours after test substance application. The ocular irritation scores should be evaluated in conjunction with the nature and severity of lesions, and their reversibility or lack of reversibility. Use of topical anesthetics and systemic analgesics to avoid or minimize pain and distress in ocular safety testing procedures is described.

This Test Guideline describes an in vitro assay that may be used for identifying water soluble ocular corrosives and severe irritants as defined by the UN Globally Harmonized System of Classification and Labelling, Category 1. The assay is performed in a well where a confluent monolayer of Madin-Darby Canine Kidney (MDCK) is used as a separation between two chambers. It uses a fluorescein dye as marqueur. The test substance has the potential to impair the junctions of the MDCK cells and thus to increase the monolayer¡¯s permeability. Consequently the fluorescein passes through the monolayer and the fluorescein leakage (FL) increases. The FL is calculated as a percentage of leakage relative to both a blank control and a maximum leakage control. The concentration of test substance that causes 20% FL (FL20, in mg/mL) is calculated and used in the prediction model for identification of ocular corrosive and severe irritants. The cut-off value of FL20 to identify water soluble chemicals as ocular corrosives/severe irritants is ¡Ü 100mg/mL. The FL test method should be part of a tiered testing strategy.

This Test Guideline describes in vitro assays, which use Androgen Receptor TransActivation (ARTA) to detect Androgen Receptor Agonists and Antagonists. The ARTA assay methods are mechanistically and functionally similar test methods that provide information on the transcription and translation of a reporter gene following the binding of a chemical to the androgen receptor and subsequent transactivation. The cell lines used in these assays express AR and have been stably transfected with an AR-responsive luciferase reporter gene, and are used to identify chemicals that activate (i.e. act as agonist) or inhibit (i.e. act as antagonists) AR-dependent transcription. Some chemicals may, in a cell type-dependent manner, display both agonist and antagonist activity and are known as selective AR modulators. The AR is activated following ligand binding, after which the receptor-ligand complex binds to specific DNA responsive elements and transactivates the receptor gene, resulting in an increase cellular expression of the luciferase enzyme. The enzyme then transforms the substrate to a bioluminescent product that can be quantitatively measured with a luminometer. This Test Guideline includes ARTA assays using the AR-EcoScreenTM cell line, the AR-CALUX® cell line, and 22Rv1/MMTV_GR-KO cell line.

The present Key Event based Test Guideline (TG) addresses the human health hazard endpoint skin sensitisation, following exposure to a test chemical. More specifically, it addresses the activation of dendritic cells, which is one Key Event on the Adverse Outcome Pathway (AOP) for Skin Sensitisation. Skin sensitisation refers to an allergic response following skin contact with the tested chemical, as defined by the United Nations Globally Harmonized System of Classification and Labelling of Chemicals (UN GHS). This TG provides three in vitro test methods addressing the same Key Event on the AOP: (i) the human cell Line Activation Test or h-CLAT method, (ii) the U937 Cell Line Activation Test or U-SENS and (iii) the Interleukin-8 Reporter Gene Assay or IL-8 Luc assay. All of them are used for supporting the discrimination between skin sensitisers and non-sensitisers in accordance with the UN GHS. Test methods described in this TG either quantify the change in the expression of cell surface marker(s) associated with the process of activation of monocytes and DC following exposure to sensitisers (e.g. CD54, CD86) or the changes in IL-8 expression, a cytokine associated with the activation of DC. In the h-CLAT and U-SENS assays, the changes of surface marker expression are measured by flow cytometry following cell staining with fluorochrome-tagged antibodies. In the IL-8 Luc assay, the changes in IL-8 expression are measured indirectly via the activity of a luciferase gene under the control of the IL-8 promoter. The relative fluorescence or luminescence intensity of the treated cells compared to solvent/vehicle control are calculated and used in the prediction model, to support the discrimination between sensitisers and non-sensitisers.

This Test Guideline describes a cytotoxicity-based in vitro assay that is performed on a confluent monolayer of Statens Seruminstitut Rabbit Cornea (SIRC) cells, cultured on a 96-well polycarbonate microplate. After five-minute exposure to a test chemical, the cytotoxicity is quantitatively measured as the relative viability of SIRC cells using the MTT assay. Decreased cell viability is used to predict potential adverse effects leading to ocular damage. Cell viability is assessed by the quantitative measurement, after extraction from the cells, of blue formazan salt produced by the living cells by enzymatic conversion of the vital dye MTT, also known as Thiazolyl Blue Tetrazolium Bromide. The obtained cell viability is compared to the solvent control (relative viability) and used to estimate the potential eye hazard of the test chemical. A test chemical is classified as UN GHS Category 1 when both the 5% and 0.05% concentrations result in a cell viability smaller than or equal to (≤) 70%. Conversely, a chemical is predicted as UN GHS No Category when both 5% and 0.05% concentrations result in a cell viability higher than (>) 70%.

This Test Guideline describes the Medaka Extended One Generation Test (MEOGRT), which exposes fish over multiple generations to give data relevant to ecological hazard and risk assessment of chemicals, including suspected endocrine disrupting chemicals (EDCs).  Exposure in the MEOGRT starts with spawning fish (P or F0 generation) and continues until hatching (until two weeks post fertilization, wpf) in the second (F2) generation. This Test Guideline measures several biological endpoints.  Primary emphasis is given to potential adverse effects on population relevant parameters including survival, gross development, growth and reproduction (fecundity).  Secondarily, in order to provide mechanistic information and provide linkage between results from other kinds of field and laboratory studies, where there is a posteriori evidence for a chemical having potential endocrine disrupter activity (e.g. androgenic or oestrogenic activity in other tests and assays) then other useful information is obtained by measuring vitellogenin (vtg) mRNA (or vitellogenin protein, VTG), phenotypic secondary sex characteristics (SSC) as related to genetic sex, and evaluating histopathology.